PRODUCTS
- Mechanical seal of boiler feed pump
- Mechanical seal of circulating pump
- Slurry pump mechanical seal
- Mechanical seal of desulfurization
- Mechanical seal of agitator
- Compressor mechanical seal
- Sewage pump mechanical seal
- Chemical pump mechanical seal
- Metal bellows mechanical seal
- Heat conduction oil pump mechanical
- Mechanical seal of sanitary pump
- Clean water pump mechanical seal
- Mechanical seal of booster pump
- Air-conditioning pump mechanical se
- Mechanical seal of reaction kettle
- Mechanical seal of Chinese standard
- Mechanical seal of paper pulp pump
- Mechanical seal of pressure screen
- Water pump accessories
126 series mechanical seals combine the spring, corrugated sealing ring, moving ring and transmission sleeve in the moving ring seat by means of the blocking channel, so that the other parts form a whole, which is convenient to install and use.
Using corrugated packing ring, solve the pump shaft in medium after long-term use, make o-rings with pump shaft rust cannot move freely on the pump shaft, causing the seals cannot be compensated by wear and product leakage problem, and solve the pump pump shaft sealing surface caused by the up move off, the seal failure problem, applied more widely.
Working parameters
Rules: 30 ~ 80 mm
Pressure: 1.2 Mpa or less
The temperature: - 20-150 ℃
Wire speed: ≤15m/s
Axial channeling momentum: ±1.0mm
Material combination
Sealing end face: graphite, silicon carbide, tungsten carbide
Auxiliary sealing: nitrile rubber, fluorine rubber, ethylene rubber, silicone rubber, PTFE
Metal component: SUS304, SUS316L
The product description
Single face internal flow
The balanced
Arbitrary spin to
Comply with EN12756(DIN24960) standards
In the development and design of any product, we follow the principle of installation size standardization. That is, the installation ruler of this type of mechanical seal is in accordance with international and domestic (API610, API682, DIN24960, ISO3069, GB6556).